Borgeson – Steering Shaft Support – P/N: 670000 – Steering shaft support bearing. Billet steel. Tapped to receive two 5/16 in.-18 bolts. Supports all 3/4 in. splined and Double-D steering shaft.

If more than two joints are used in a steering system, a support bearing must be used to prevent "looping" and binding. Use of a vibration reducer and two u-joints will also call for a support bearing to be used. A system with a double u-joint and a single u-joint has three flex points and will require a support bearing. Support bearings will work with all 3/4" splined or Double D steering shafts. All billet supports accommodate a 3/4" shaft. Our standard supports are 2-1/2" tall with two 5/16"-18 threaded holes in the end for mounting and are available in steel, aluminum, polished aluminum, stainless steel, and polished stainless steel. The 6" cut and weld billet support is available only in steel and can be cut at any angle for a perfect fit.

Additional Attributes:

GTIN: 00843975003535
Inside Diameter: .750
Width: 2.00
CA Prop 65 Required: Y
Height: 2.50
Prop 65 – Long Label: WARNING: This product can expose you to chemicals including Nickel and Chromium (hexavalent compounds), which are known to the State of California to cause cancer or birth defects or other reproductive harm. For more information visit: www.P65Warnings.ca.gov
Thickness: .625

Extended Information:

Emissions : Emissions Compliance Exempt
Life Cycle Status: Available To Order

Packaging:

Quantity of Each: 1
Package UOM: EA
Dimension: 1.75 x 3.75 x 5.75 inches
Weight: 0.74 PG

PDF:

Universal_Component_Instructions