The COMP camhaft checking tool is designed to slide into the lifter bore and ride on the cam lobe. A dial indicator is then attached to the checking tool so that lobe lift and base circle runout can be measured. Fits .904" bores.
The COMP camhaft checking tool is designed to slide into the lifter bore and ride on the cam lobe. A dial indicator is then attached to the checking tool so that lobe lift and base circle runout can be measured. Fits .904" bores.
The COMP camhaft checking tool is designed to slide into the lifter bore and ride on the cam lobe. A dial indicator is then attached to the checking tool so that lobe lift and base circle runout can be measured. Fits .842" and .875" bores.
The COMP camhaft checking tool is designed to slide into the lifter bore and ride on the cam lobe. A dial indicator is then attached to the checking tool so that lobe lift and base circle runout can be measured. Fits .842" and .875" bores.
This degree fixture enables you to measure camshaft lobe lift with the heads off the block while degreeing a cam. Much better than using a magnetic base.
This degree fixture enables you to measure camshaft lobe lift with the heads off the block while degreeing a cam. Much better than using a magnetic base. This is designed specifically for 1/2" Head Studs.
This degree fixture enables you to measure lift at the valve with the heads-on. This enables you to verify the accuracy of your rocker ratio, ensure piston to valve clearance and ensure that you are accurrately degreeing your cam.
This tool enables you to measure your camshaft's lobe lift by inserting this tool into the lifter bore, adjusting the body diameter and attaching the included dial indicator.
