Exhaust Heat Shield

One multi-piece pre-cut insulation kit.

• Reduces Engine Noise And Vibration
• No Modifications Are Needed For Installation
• Made In The USA
• Blocks Heat Build Up In The Cockpit Area
• Fits models with cupholders on top of the console

One 25 foot roll of 2 inch wide Black Titanium exhaust wrap and 6 stainless steel positive locking ties.

• Constructed from high grade 316 stainless steel
• Capable of withstanding in excess of 2500°F
• Tensile Strength: 5/16" 200 lbs., 1/2" 350 lbs.
• 8" + 14" Pack includes eight 8" ties and four 14" ties
• Tool fits on the end of any 1/4" drive extension
• Tool works with all popular styles of stainless ties up to 1/2"
• Tool is made from hardened tool steel and black oxide coated for

One pre-cut insulation kit.

• Installs under the factory or aftermarket heat shields
• Improves heat shield performance
• Pre-cut to fit your heat shields
• Not visible when installed
• No need to remove exhaust system

One multi-piece pre-cut insulation kit.

• Blocks excessive heat from the engine bay
• Lowers temperatures on the seat and middle plastic panel
• Includes foot well protection for the rear passenger
• Easily removable for service
• Made in the USA

One 15 oz. can of ATAC Spray-On.

• Seals and stops the spread of rust
• High solids zinc formula with corrosion resistant additive
• Outstanding adhesion to most metal surfaces
• All the advantages of solvent based products without the use of hazardous chemicals
• Does not require a top coat, but can be finished with most latex paints or coatings
• Environmentally friendly
• Excellent waterproofing and chemical resistance
• Easy clean up while with soap and water

One tube of ATAC Seam Sealer.

• Excellent adhesion to bare, primed, and painted surfaces
• For use on steel, aluminum, or fiberglass
• No sagging, shrinking, or cracking
• Ready to paint after only one hour
• Urethane based formula - remains flexible after drying

One quart can of red oxide primer.

• Seals and stops the spread of rust
• High solids zinc formula with corrosion resistant additive
• Outstanding adhesion to most metal surfaces
• All the advantages of solvent based products without the use of hazardous chemicals
• Does not require a top coat, but can be finished with most latex paints or coatings
• Environmentally friendly
• Excellent waterproofing and chemical resistance
• Easy clean up while with soap and water

MUD FLAP, HEAT SHIELD KIT

• Heat shield is a 1.0 mm thick stainless steel plate.