Carburetor Spacer

This billet aluminum construction manifold spacer is designed to raise the mounting height of a throttle body or carburetor 1 inch above a 4150 flange intake manifold.

The Edelbrock Carburetor Spacer #8710 Open hole spacers are used where more plenum volume or more carb-to-plenum floor distance is required.

The Edelbrock Carburetor Spacer #8711 4-hole design enhances low-rpm torque and throttle response and dampen reversion effects on the carb.

The Edelbrock Carburetor Spacer #8712 is an open design used to add more plenum volume or add more distance from carb-to-plenum floor distance.

Edelbrock Carb Spacer 2-Inch 4-Hole

Edelbrock Carb Spacer 1-Inch Divided

Edelbrock Carb Spacer 1/-Inch Divided

Edelbrock Carb Spacer 1-Inch 4500 Carb Spacer

Edelbrock Carb Spacer 1-Inch Cloverleaf Design

Edelbrock Carb Spacer 3/4-Inch Wood Spacer

Edelbrock Carb Spacer 1-Inch Wood Spacer

Edelbrock Carb Spacer 1/2-Inch Divided

Edelbrock Carb Spacer 1/2-Inch 4-Hole

Edelbrock Carb Spacer 1/2-Inch Open Wood Design

Edelbrock Carb Spacer 1/2-Inch Divided Wood Design

Edelbrock Q-Jet Spacer , Wood, 3/4 Inch